The most advanced is the Landice Executive control panel, which has a color touchscreen and Bluetooth for connecting with mobile apps. Each Landice control panel is packaged with a Polar chest strap for wireless heart rate monitoring. Executive Control Panel A luxury selection, the Executive is the only Landice control panel with full color and workout graphics. The Landice Executive provides the most preset programs of any Landice control panel. RunSocial is another benefit of choosing the Executive. By connecting your mobile app over Bluetooth, you can virtually train in exciting settings around the globe, either solo or with other RunSocial app users.
|Published (Last):||25 April 2015|
|PDF File Size:||13.18 Mb|
|ePub File Size:||10.21 Mb|
|Price:||Free* [*Free Regsitration Required]|
The speed sensor will pick up this increase in flywheel speed and sends this information up to the display electronics.
The microprocessor will then compare the actual speed to the displayed speed, determine a runaway speed condition and shut the treadmill down. An overspeed will display in the window. This is a safety feature built into all treadmills that utilize closed loop speed circuitry. B Similar to the gravitational force, a user can be holding onto the handrails and pushing the running belt in such a manner where they are using the treadmill like a manual machine rather than a motorized one.
User needs to set speed compatible for their actual walking or jogging speed so they are not pushing the belt. However, this problem is becoming rare due to the PWM circuitry which senses this condition and shuts itself down before the drive motor receives any DC voltage at all.
This is a safety feature on all Landice home treadmills with PWM motor control boards. The SCR motor control boards also have internal protection to prevent an over speed condition from occuring due to an internal component failure.
In the rarest of cases, on home treadmills, a faulty relay board can cause an OS or O5. The reading should be between VDC. The reading should be between 0. If either of these voltages measure zero, replace the relay board. D Get into Open Loop Speed mode and check the speed. Adjust pots as necessary to bring up correct speed for max and min.
Reset connection if necessary. If so, calibrate the elevation potentiometer. B If elevation system does not work properly in diagnostics mode, determine which button or direction has the problem. Do this by disconnecting the elevation motor from the relay board. If neither lights were lit when corresponding button was held, then inspect the orange UP wire and the purple DOWN wire on both the wire connector on the relay board and the wire connector on the uppder display board for loose connections or pushed pins.
If all harness connections are intact, then replaace the upper display board. C If elevation system does not work properly in diagnostics mode, determine which button or direction has the problem.
If both lights were lit when corresponding button was held, then again hold the UP button on the display and verify if the yellow UP light on the relay board is lit and then hold the DOWN button on the display and verify if the yellow DN light on the relay board is lit. If connections are intact, replace the elevation motor. Replace upper display board or relay board if necessary. Correct wiring if necessary.
Also check the brush springs and verify that the brush copper wire is not burned or broken. Replace both motor brushes if necessary. E Inspect motor turns and is not seized up or has a broken shaft. Replace motor if necessary. If no voltage present, replace drive motor. Replace board. Replace board ERR 8- Upper board serial port pin error check harness connections ERR Communication Error Note: If two or more errors are detected, the code will be the sum of the individual error codes.
Landice L9 User Manual
Landice Treadmill Parts
Landice Treadmill manuals
Landice L7 Service Manual