Overview[ edit ] Mobile Networks require a kind of synchronization The aim of Synchronous Ethernet is to provide a synchronization signal to those network resources that may eventually require such a type of signal. The Synchronous Ethernet signal transmitted over the Ethernet physical layer should be traceable to an external clock, ideally a master and unique clock for the whole network. Unlike time-division multiplexing networks, the Ethernet family of computer networks do not carry clock synchronization information. Several means are defined to address this issue. Synchronization for SDH can be transported over Ethernet and vice versa. These clocks are referred to as Ethernet Equipment Slave clocks.
|Published (Last):||27 January 2005|
|PDF File Size:||19.69 Mb|
|ePub File Size:||8.96 Mb|
|Price:||Free* [*Free Regsitration Required]|
Synchronous Ethernet The requirements for the jitter and wander characteristics that are specified in this Recommendation must be adhered to in order to ensure interoperability of equipment produced by different manufacturers and a satisfactory network performance. It also outlines the minimum requirements for the v function of network elements.
Temperature y underground containers for the installation of repeaters. Rogue optical network unit ONU considerations. Unlike time-division multiplexing networks, the Ethernet family of computer networks do not carry clock synchronization information. Measurement of the load of telephone circuits under field conditions.
A general requirement for SyncE was that any network element NE should have at least two reference clocks, and in addition, Ethernet interfaces must be able to generate their own synchronization signal in case they lose their external reference. Ethernet family of local area network technologies. G-PON interoperability test plan between optical line terminations and optical network units.
SyncE networks do not usually have only one topology, but rather a combination of all of them. Patent statement s Development history. The itk and transport networks are partially mixed, since some NEs both transmit data and distribute clock signals to other NEs. Guidance for Ethernet OAM performance monitoring. The most common topologies are:.
Test plan to verify B-PON interoperability. Duplication and security involving more than one master clock, and the existence of some kind of synchronization management protocol, are important features of modern networks.
Simulations of transport of time over packet networks. Views Read Edit View history. Overview of digital subscriber line Recommendations. A synchronization loop is a completely unstable situation that may provoke an immediate collapse of part of the network within the loop.
General aspects of optical fibres and cables. G : Timing and synchronization aspects in packet networks Optical fibre and cable Recommendations and standards guideline. It specifies the minimum equipment tolerance to and wander that shall be provided at the boundary of these packet networks at TDM and synchronization interfaces.
Feedback Contact Us Accessibility. Group-delay distortion performance of terminal equipment. Synchronous Ethernet — Wikipedia The aim is to minimize the problems associated with signal transport, and to avoid depending on only tiu clock in case of failure. Study Groups tree view.
However, in Ethernet there is no equivalent of a fixed frame. Jitter and wander accumulation in digital networks. Synchronization for SDH can be transported over Ethernet and vice versa. Interference from external sources. Several means are defined to address this issue. Mathematical models of multiplex signals. SyncE architecture minimally requires of the internal clock of the Ethernet card by a phase locked loop in order to feed the Ethernet PHY.
This page was last edited on 24 Aprilat Optical transport network module framer interfaces. Most 10 Related.