The device is extensively documented in the User Guide, including instructions in use of software to communicate with it. However, the battery may not provide optimal performance and life over the entire temperature range. Further details are discussed in the Firmware section , below. The unit can either start logging automatically, or after pressing the start button.
|Published (Last):||7 November 2008|
|PDF File Size:||7.36 Mb|
|ePub File Size:||10.60 Mb|
|Price:||Free* [*Free Regsitration Required]|
The device is extensively documented in the User Guide, including instructions in use of software to communicate with it. However, the battery may not provide optimal performance and life over the entire temperature range.
Further details are discussed in the Firmware section , below. The unit can either start logging automatically, or after pressing the start button. It shows a little running-man icon on the left side while logging. To store a waypoint while logging, one must be in the menu that displays latitude and longitude. Pressing the Enter button logs the waypoint, and confirms it by briefly displaying a little flag icon in the bottom left corner. Battery The M can log GPS points for up to 12 hours with one alkaline AA cell recommended at room temperature, 10 hours at high temperature or 2 hours at low temperature.
An ordinary carbon-zinc cell can power it up to 4 hours at room temperature. A Ni-MH mAh rechargeable AA cell is specified to power it up to 10 hours at room temperature, and if a mAh cell is used, users have reported up to 12 hours usable life. Frequent activation of the backlight will shorten battery life. Although the M User Manual expressly states that it cannot recharge cells, at least two users have reported success with rechargeable Ni-MH cells.
When the Ni-MH cell is nearly depleted, connect the M with the cell still inside to a USB power-only adapter no data wires and it may begin to get recharged slowly. If you want to try charging a cell while it is in the M, it is recommended to not wait until the battery is depleted: One can charge Ni-MH batteries even with remaining charge, without risk of "memory effect". To get those, use the script from Saving waypoints with Holux M There is a how-to, Holux M and Arch Linux Archived on , but note that the gpsbabel command-line provided there is not correct anymore.
Mtkbabel creates you a file called XXX. You need to set -s using USB. For Bluetooth, default speed should work. Note that the NMEA Interface Standard specifies serial communication speed at baud, although the M is capable of exceeding this speed when connected to a suitable host. You can easily send custom commands by editing the source code.
See Software hacks , below. Further configuration can also be done by command line switches. See --help. Comment: "Mtkbabel works better for me. It makes a track from every time you switch on the device and you will get the waypoints.
I did not get them with gpsbabel. BT software BT software works on Linux. See the Microsoft Windows section for general details. Each requires a slightly different setup. Additionally, since there are various Bluetooth implementations "stacks" , you may have to adjust these instructions for particular software-hardware combination. Bluetooth First, make sure the Holux M has Bluetooth turned on.
Have your computer search for Bluetooth devices. Your Bluetooth applications will likely be slightly different. Also, if the battery in the M is dead, you can power it via USB, even while using Bluetooth connectivity.
Holux M-241 Manuals & User Guides
Yes, the Funtrek GM can support third party software. Just need to do some simple settings then the third party software will embedded on our system. But first of all, please make sure your third party software can match the conditions below: It can operated under WinCE 5. And you can do similar setting on your 3th party software as same as our example, it can be added many kind of application software into GM Please try to contact our sales unit, it would be processed by special project. The software ezTour Plus can only operate under Windows platform.
Holux M-241 plus GPS Data Logger
Holux M-241 User Manual
- CISCO ASA 5585 X DATASHEET PDF
- AWRY ARCHERS OF AVALON PDF
- INTRODUCTION TO HYDROCODES ZUKAS PDF
- CONCIERTO BARROCO ALEJO CARPENTIER PDF
- I821D FORM PDF
- BROS BEFORE HOS THE GUY CODE MICHAEL KIMMEL PDF
- 2003 4RUNNER OWNERS MANUAL PDF
- GENTE PELIGROSA PHILIPP BLOM PDF
- LIVING WITH HONOUR BY SHIV KHERA FREE PDF