Battery is disconnected and utility power is not available at the wall outlet. Connect the battery see Connect Battery and ensure power is available at the wall outlet. No power available at the Surge Protection outlets. Surge Protection outlets have been overloaded. Reduce the amount of equipment plugged into Surge Protection outlets.
|Published (Last):||9 August 2019|
|PDF File Size:||5.59 Mb|
|ePub File Size:||19.38 Mb|
|Price:||Free* [*Free Regsitration Required]|
Battery is disconnected and utility power is not available at the wall outlet. Connect the battery see Connect Battery and ensure power is available at the wall outlet. No power available at the Surge Protection outlets. Surge Protection outlets have been overloaded.
Reduce the amount of equipment plugged into Surge Protection outlets. Utility power not available at the wall outlet. Ensure that the fuse or circuit breaker for the outlet is not tripped, and that the wall switch controlling the outlet if any is in the ON position.
Connected equipment loses power. Make sure that the equipment plugged into the outlets of the unit are not overloading the capacity of the unit. Try removing some of the equipment and see if the problem continues. PowerChute Personal Edition software has performed a shutdown due to a power failure. The unit will eventually turn off when the available battery power has been used.
Allow the unit to recharge for 16 hours before continuing use of the unit. The output waveform is designed for computers and computer-related equipment.
It is not designed for use with motor-type equipment. Once On Battery, you should save your current work, power down your equipment, and turn the unit OFF. Once normal power is restored, you may turn the unit back ON and power your equipment. Battery capacity is low about 2 minutes of use remaining. When the unit beeps once every second, the battery has about 2 minutes of power remaining. Immediately power down your computer and turn the unit OFF.
When normal power returns, the unit will recharge the battery. Building Wiring Fault indicator is lit. Your building wiring presents a shock hazard. Using the Back-UPS with this condition will void the warranty. Call a qualified electrician for service. Inadequate runtime. The battery is not fully charged. Allow the unit to charge by leaving it plugged into the wall at least 16 hours. Battery is near the end of useful life. As a battery ages, the amount of runtime available will decrease.
You can replace the battery by ordering one at www.
APC Back-UPS ES 350 BE350G-LM Manual De Usuario
APC ES 550 User Manual
APC BACK-UPS ES 350 MANUAL EPUB DOWNLOAD